BLOG

KTN will participate in the oil and gas fair in Kuala Lumpur

KTN will participate in the oil and gas fair in Kuala Lumpur

THE EVENT KTN STAND INVITATIONS We are going to visit Malaysia one of the most relevant emerging markets in the oil & gasKTN will participate in the oil and gas fair in Kuala LumpurThe sixth edition of the Malaysian Oil and Gas Services Exhibition and Conference...

Pneumatic actuators: single acting vs double acting

Pneumatic actuators: single acting vs double acting

ARTICLE CONTENTS DIFFERENCES BETWEEN SINGLE AND DOUBLE ACTING WHICH IS THE BEST OPTION CONCLUSION DIFFERENCES BETWEEN SINGLE AND DOUBLE ACTING A pneumatic actuator is a device that transforms the energy of compressed air into mechanical energy, this characteristic...

KTN Case study

KTN Case study

CASE STUDIES Successful case studies applications with our range of high performance products SULFUR APPLICATION BOAT BILGE APPLICATION NUCLEAR PLANT APPLICATION These are some KTN success case studies with our metal-to-metal seated ball valves for very demanding...

How to determine the tightening torque of a flange?

How to determine the tightening torque of a flange?

CONTENTS OF THE ARTICLE TORQUE THEORY ASSEMBLY CALCULATION OF TORQUE TABLES TIGHTENING TORQUE THEORY In this article we will teach you to determine the minimum torque applicable to the screws that join the flat gaskets and the flanges . References: American Society of...

Customizable seat materials available for our valves

Customizable seat materials available for our valves

Customizable seat materials available for our valves Practical guide where we review the mechanical and chemical qualities of our available seat materials to illustrate your choice. BUNA SEATS DELRIN SEATS DEVLON SEATS EPDM SEATS HYPALON SEATS NEOPRENE SEATS NYLON...

¿How to properly torque a flange?

¿How to properly torque a flange?

Technical Department How to torque a flange properly? In this post we emphasize the importance of knowing how to properly torque a flange and we will show some tightening sequence patterns. The tightening sequence allows us to control the tension variation without...

Equivalences between millimeters and microns

Equivalences between millimeters and microns

MESH: EQUIVALENCIES BETWEEN MILIMETERS AND MICRONS mm = µm Exact filtration light equivalences between millimeters and microns in values from the mesh table.HOW DOES FILTRATION OCCUR? Filtration occurs after theseparation of the solids in suspension...

CONVERSION TABLE DN TO INCH

CONVERSION TABLE DN TO INCH

DN = NPSDiameters in DN or in NPSFrom within the industrial market we find these two systems to size the diameters for pipes, tubes, valve connections and other devices: Nominal pipe size (NPS) , defined by the...

1